Fascination About oec c arm

C Elimination The "C" will be the C-shaped weldment that supports the X-ray tube and Collimator on a single conclusion plus the Graphic Intensifier and CCD digicam on the opposite finish. Taking away the C is a simple task but some large lifting is concerned. Comply with these techniques:

Disassemble brake in accordance with Guidance in Substitute chapter and Test brake shoe for use. Exchange brake shoe if vital.

Stator Control The X-ray tube’s anode will have to rotate Each time the method generates X-rays to circumvent damage to the anode. Technique software rotates the anode by making use of get started and run voltages on the stator winding on the X-ray tube.

The collimator is controlled by application throughout the Fluoro Functions PCB. The Shutter Width, Rotation and Iris motors established the size and shape of your x-ray beam underneath Charge of the operator. The connected pots affirm the movement and posture with the collimator parts back on the software package.

Purposeful Exams Execute the subsequent assessments to verify appropriate operation with the C-Arm's suspension and steering factors.

Soon after completing the Guidelines on the laptop, select the File pull down menu and select the Help save Workstation Calibration File to avoid wasting the new gentle sensor calibration data.

Useful Assessments Generate a Fluoro publicity and observe the kV readout within the control panel. The readout should remain regular on the specified kV method.

X-ray from the beam alignment Resource and mark the middle from the alignment tool on the check with a small dot applying an erasable marker.

Boot Sequence Display on C-Arm User interface The C-Arm User interface has a twenty-character Display screen that provides a visible indication of your C-Arm’s development inside the boot sequence. The amount of squares or arrows about the display signifies how much the bootup has progressed. If an error happens through bootup, a information describing the mistake appears around the C-Arm User interface shows on the conclusion of the boot sequence.

Tungsten Collimator could be the perform that denser collimator limitations X-ray publicity region to lessen scatter radiation, which improves impression element.

OEC software program executes underneath the Nucleus® working method. The OEC programs and functioning technique are both of read the article those located in the non-DOS formatted 50 Mb percentage of the hard drive. File administration and related utilities are located to the DOS-formatted part of the hard disk drive.

Connect a resolution Software for the encounter of the main target grid near the center at a forty fiveº angle (see drawing, Beam Alignment part, previously In this particular chapter).

The trimpot R71 turns counterclockwise to improve, or clockwise to decrease the output voltage. Verify that high cost mode is just not engaged. In the event the battery charger output voltage is simply too more info here higher in usual cost manner, this may cause the mistake concept PRECHARGE VOLTAGE ERROR, and stop completion of precharging.

Orient the Software over the picture tube to ensure when the collimator iris is closed partly, the ruler marks within the Software intersect the flat portions of the collimator iris.

Leave a Reply

Your email address will not be published. Required fields are marked *